Service Hotline
+1 4152729688
KRAUS& What is the working principle of NAIMER universal transfer switch?
2023-09-22 17:53:04
The German KRAUS&NAIMER CAM switch is an electromechanical switch that works using the rotation effect. It can transfer electricity from one place to another. The switch rotates at different angles with the help of levers and shafts, allowing electrical energy to be transferred from one point to another where it is needed. The result of turning the handle is that the contact on the handle changes position. Packet switches can be used instead of buttons when starting and stopping low-power electrical equipment (energizing and isolating loads) and control circuits. In addition, pacco switches are used for on and off operations in motor control circuits, motor start in star-triangle and direct start circuits, motor forward and reverse operation, control switches in two-speed motors, measurement switches in measurement circuits, and energy in control circuits. They can be used for orientation purposes. The maximum current of the CAM switch produced can reach 200A with a maximum of 8 poles.
CAM switches should not be confused with load isolation switches. Although they are similar in construction, load isolation switches generally operate 1-0 and can isolate higher currents. On the other hand, CAM switches can be operated in more positions and give different energy directions at each position.
In addition, pacco switches and contactors work completely differently. Yes, both electrical energy is direct, but the pacco switch is manually controlled, and the contactor directs the energy after the coil is energized. In other words, the contactor needs electricity to work.
On-off pacco switch: The pACCO switch has 1 bit and 0 bit. Pole-changing pacco switches: There are 1-0-2 position stepper switches: there are 0-1-2-3 position voltmeters or ammeter commutators: These are connected to an ammeter or voltmeter to display phase-neutral/phase-neutral voltage and current at a selected location.
Control Pacemaker switches: have start-stop positions, multistage pacco switches: they have 0-1-2-3-4 form positions, star-triangle pacco switches: They are used for manual star-triangle starts.
Transfer switch: Used to manually start and control the motor forward and backward. Dahlander CAM switches: These are used in Dahlander circuits.
The above content is introducedKRAUS&NAIMERUniversal change-over switchHow does it work? The problem. In addition, Shenzhen Oudejie Technology specializes in selling new original German imported KRAUS&NAIMER universal switch, and promises to sell products are new original imports, while providing our customers with quotation, selection, product information and other services。
