1. Use the green tool box 6GK1901-1GB01 (5.1 mm gap) in the wire stripping tool. If your stripper is equipped with

Yellow knife box, the cutting depth must be adjusted with the middle hexagon after the new cassette is installed and tightened!

2. Hold the cable stripper in your right hand.

3. Measure the cable length against the measurement template. Use your left index finger as the limit.

4. Insert the cable into the cable stripping tool. Your left index finger is the limit point.

5. Tighten the cable stripping tool completely.

6. To strip the insulation, turn the tool in the direction of the arrow - approximately. PVC insulation 4 times, -PUR insulation about 8 times.

7. Keeping the stripping tool closed, pull it to close the end of the cable with the jacket and shield remnants.

8. If the white caulk does not insulate, remove it and the clear hand protective foil.

9. Cut off the fake core.

10. Mark the FC RJ45 plug according to the color on the contact element.

11. Open bracket cover (e) until it locks and color-code according to their push-in wires * until limit stop bracket cover.

12. Push the cable into the position picture as shown (see arrow). Press the contact element to the limit to stop touching the wire.

13. Close the lid and turn the mechanism locking the arrow direction by hand as much as possible.

14. Insert the 2.5mm screwdriver into the hole in the locking mechanism and turn it until the limit stops.

15. When the connector is correctly locked, the opening of the locking mechanism points to the side and the surface is flush with the surface of the connector.

16. If the space is too small, loosen the screwdriver (2.5mm blade width).

The above content is the disassembly method of Siemens network cable connector, in addition, Shenzhen Oudejie Technology specializes in selling original imported Siemens network cable connector, and promises to sell products are new original imported, while providing our customers with quotation, selection, product information and other services.